Troubleshooting guide

Sony TV Red Light Blinking: What 5 or 6 Blinks Mean

When a Sony TV detects a hardware fault it shuts down and blinks the red standby light in a repeating pattern. Counting the blinks tells a technician where to look. Here is what the common patterns usually indicate on Sony Bravia LED and LCD TVs.

Independent repair service · not affiliated with Sony

Sony TV red light blink codes – quick reference

Blink codes vary between Sony models and years. Treat this table as a guide; a technician confirms the actual fault with tests.

Sony TV red light blinking 5 times

Five blinks on most Sony Bravia LED models points to a display-path fault – typically the T-con (timing control) board, the flat cables to the panel, or the panel itself. The TV powers up, detects that the panel is not responding and shuts down.

In many cases the fix is a T-con or cable repair rather than a new screen. If the panel itself has failed, see our Sony TV screen repair page for what replacement involves.

Sony TV red light blinking 6 times

Six blinks is one of the most common faults we see in Mysore. It usually means a backlight failure: one or more LED strips behind the screen have burned out, or the LED driver circuit has failed. Often the TV shows the picture for a few seconds, goes dark and then starts blinking.

The good news: backlight repair is usually far cheaper than a new screen. The technician opens the TV, tests each LED strip and replaces the faulty strips or the driver. Read more about backlight and power board repair.

Safe checks you can try first

  1. Hard reset: unplug the TV from the wall for 2–3 minutes, then plug it back in and switch on.
  2. Try another socket and remove any extension board or stabiliser temporarily.
  3. Remote power reset (Google/Android TV): hold the power button on the remote for about 5 seconds until the TV restarts.
  4. Count again: note the exact number of blinks between pauses – it helps us bring the right parts.

Do not open the TV yourself. Power boards hold high voltage even after unplugging. If the blinking returns, book a technician.

FAQs

Frequently asked questions

Why is my Sony TV red light blinking?

The TV has detected an internal fault and shut down to protect itself. The number of blinks between pauses is a diagnostic code that points to the faulty section, such as the power supply, backlight or display board.

What does Sony TV red light blinking 6 times mean?

On most Sony Bravia LED TVs, 6 blinks indicates a backlight problem – failed LED strips or the LED driver. It is usually repairable without replacing the screen.

What does Sony TV red light blinking 5 times mean?

Five blinks usually points to the display path: the T-con board, panel cables or the panel. A technician tests each part to confirm which one has failed.

Can I fix a blinking red light myself?

A hard reset (unplugging for a few minutes) sometimes clears a one-time error. If blinking returns, it is a hardware fault and the TV should be opened only by a technician because of high voltage inside.

Do you repair Sony TV red light blinking problems in Mysore?

Yes. We repair red light blinking faults on Sony Bravia TVs at your home across Mysuru. Book online.

Book your Sony TV technician in Mysore

Takes about a minute. You get a booking ID instantly.